Installation if your hardware into the LM200 is pretty straight forward. You first want to remove the horizontal mounting plate to give you a little more room to work with. Once we have that removed we can go ahead and install our power supply, just mount it on the back with screws, pretty simple.
Next is the motherboard, install the standoff’s for your motherboard. Then go ahead and place the motherboard in and secure it with screws. We are using a standard mATX motherboard and we had a good amount of room inside to work with.
Before we go ahead and install our drive go ahead and connect everything you can. You want to do this because it will be quite hard to get everything connected when you have the horizontal mounting plate back inside the case. As you can see it is a bit messy, but we will clean it up once we get everything in there.
Now to install our drives, to do this take the horizontal mounting plate and place it on top of your optical drive and line up the holes and screw it into place. This seems so simple, hopefully it lines up with the door on the front of the case. Now for our hard drive, same thing just line it up and secure it with screws, that’s quite simple. Now take the entire mounting bar and reinstall it into the case.
Just connect everything back up and your ready to close the case up. With everything installed there is still a good amount of room inside the case.
Apr 25, 2015 0
Apr 24, 2015 0
Apr 24, 2015 0
Apr 23, 2015 0