Installation
Installation is rather simple for the Ironclad. First you need to start by installing the motherboard standoffs, so that you can install your motherboard. The motherboard tray is labeled so that you know exactly where to install the standoffs.

Installing expansion cards is a snap with the tool-free device. Just simply pull up on the lever; this will release the bay cover usually making it fall out on its own.

Then just simply install the card and push back down on lever until it’s secure.

The included drive rails make installation all that much quicker. Just simply attach the two rails to a hard drive and slide it into a slot until it snaps into position.

The same concept applies to the 5.25” drives; except that you’ll have to remove the front panel first.

Once you get the panel removed, and possibly remove any metal brackets in the way for installation, and remove the front panel bay covers, then you can just slide it into position and pop the front panel back on.

There’s quite a bit of room to work with inside of this case.

The blue LED on the side panel gives the case a nice illumination.